Promise Technology VTrack M-Class M500p Instrukcja Obsługi Pobierz pdf (Strona 39)

Chapter 3: Setup

administrator@cli> net -a mod -t mgmt -s "primaryip=192.168.10.87,

primaryipmask=255.255.255.0, gateway=192.168.10.3"

In the above example, the IP addresses and subnet mask are included as

examples only. Your values will be different.

If you prefer to let your DHCP server assign the IP address, type the

following string, then press Enter.

administrator@cli> net -a mod -t mgmt -s "dhcp=enable"

3. To verify the settings, type net and press Enter.

administrator@cli> net

===========================================

CId Port Type IP Mask Gateway Link

===========================================

1 1 Mgmt 192.168.10.87 255.255.255.0 192.168.10.3 Up

1 1 iSCSI 0.0.0.0 0.0.0.0 0.0.0.0 Down

1 2 iSCSI 0.0.0.0 0.0.0.0 0.0.0.0 Down

4. Type the following string to set the iSCSI Port IP address and other settings,

then press Enter.

administrator@cli> net -a mod -t iSCSI -p 1 -s

"primaryip=192.168.10.88, primaryipmask=255.255.255.0,

gateway=192.168.10.3"

If you prefer to let your DHCP server assign the IP address, type the

following string, then press Enter.

administrator@cli> net -a mod -t iSCSI -p 1 -s "dhcp=enable"

5. To verify the settings, type net and press Enter.

administrator@cli> net

===========================================

CId Port Type IP Mask Gateway Link

===========================================

1 1 Mgmt 192.168.10.87 255.255.255.0 192.168.10.3 Up

1 1 iSCSI 192.168.10.88 255.255.255.0 192.168.10.3 Up

1 2 iSCSI 0.0.0.0 0.0.0.0 0.0.0.0 Down

6. Repeat steps 3 and 4 to set the other iSCSI port. Use -p 2 in place of -p 1.

This completes the Management and iSCSI port setup. Go to “Install iSCSI

Initiator on the Host PC” on page 39.

To see the full set of CLI commands, at the admin@cli> prompt, type help and

press Enter.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 315 316

Brak uwag

Promise Technology VTrack M-Class M500p Instrukcja Obsługi Strona 39