Promise Technology SuperTrak SX6000 Instrukcja Użytkownika Pobierz pdf (Strona 13)

Offline Array Recovery Procedures—SuperTrak SX6000 and UltraTrak, Version 5a

13 of 34

Automatic Rebuild

When automatic rebuilding begins, the disk drive in Channel 4 reappears, confirming

that it is the target of the rebuild. The UltraTrak controller will attempt to rebuild the data

on the failed drive. If it can, the Define Array Menu will display Rebuilding progress and

the target disk drive (above).In this example, the drive on Channel 4 is being rebuilt and

progress is currently at 25 percent. Allow the UltraTrak controller to rebuild the disk

drive.

• If this action corrects the problem, return the array to service.

• If the array goes CRITICAL again and the controller tries to rebuild the same disk drive,

shut down the computer (SuperTrak) or the UltraTrak and remove the drive for

testing, as described under Remove a Disk Drive for Testing, Testing a Disk Drive,

and Results and Action, above.

If Rebuilding does not start, the array status will remain critical. Recalling which channel

the failed drive was on, you can remove the drive for testing.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 33 34

Brak uwag

Promise Technology SuperTrak SX6000 Instrukcja Użytkownika Strona 13